Forged Blades and Arrow Settings

Rob38

Category:	Graphics
Level:	Intermediate
Created:	Sunday August 12, 2007 - 19:53
Updated:	Saturday January 8, 2011 - 17:02
Views:	12024
Summary:	The steps to properly implement them into your model

Rating

Staff says

4.2

Members say

4.2

Average

4.2/5.0

16 votes

Page 1 2 3 4 5 6 7

I have noticed that many modelers on T3A struggle with the forged blades and arrow effect settings. I had this problem too, and I was frustrated by the lack of information on the subject. In this tutorial, I will show you some of the errors caused by improper settings and give a step by step process on how to set up various Forged Bladed and arrow effects properly.

NOTE: You must have Renx properly installed and know how to use Renx in order understand this tutorial. Please refer to other articles for explanations on these things.

Article Layout
Page 1 - Introduction
Page 2 - Forged Blades Basic Setup
Page 3 - Good Forged Blade Settings
Page 4 - Evil Forged Blade Settings
Page 5 - Projectile Effect Settings Basic Setup
Page 6 - Fire Arrow Settings
Page 7 - Silverthorn Arrow Settings

Comments

Display order: Newest first | Page: 1, 2

Clement (Team Chamber Member) - Monday August 13, 2007 - 6:35

No need to rescale it ;)
There is another way (that one used by EA) I'll explain it later, and see if it's possible under RenX.

Go to top

"One site to rule them all, one site to find them,
one site to host them all, and on the network bind them."

10:12:12